ABOUT

Solutions & Cases

Our Case
  • Water Pollution Control Plant Process Description

      Digester gas, which contains methane, is produced during the anaerobic digestion process and is partially re‐ circulated in the digesters to provide mixing. The excess digester gas is piped to a 600kW cogeneration engine to produce electricity and heat for the plant.

  • Water Pollution Control Plant Process Description City

    Water Pollution Control Plant Process Description Raw sewage, from across the City, is collected in large trunk sewers and flows, mainly by gravity, to the Main Pump Station at the Atlantic Avenue Water Pollution Control Plant. In the Main Pump Station, the raw sewage is pumped to a Parshall flume, where the flow is measured. The sewage then

  • Water Pollution Control Plant History and Process

    Water Pollution Control Plant History and Process Plant History The following information provided is based on current plant operational parameters. When the plant was first established, the design flow was 16 million gallons per day. Since the departure of the Plattsburgh Air Force Base, the closure of the Imperial Paper Co. Mill, and major users using less water and reducing the amount of

  • 01 Project Description New York

    Chapter 1: Project Description A. PROJECT IDENTIFICATION The Hunts Point Water Pollution Control Plant (WPCP) is located in the Hunts Point section of the Bronx, in the City of New York, and treats wastewater from portions of the Bronx, Rikers Island, City Island, and Hart Island (see Figure 1-1). The New York City Department of Environmental Protection (NYCDEP), on behalf of the City of New

  • Water Pollution Control City of Flint

    General Plant and Process Description April 28, 2020: Notice of Environmental Assessment and a Finding of No Significant Impact Water Pollution Control is City of Flint’s municipal wastewater treatment facility. WPC provides treatment to all industrial, commercial, and domestic (residential) wastewater.

  • Wastewater treatment Wikipedia

    The treatment process takes place in a wastewater treatment plant (WWTP), also referred to as a Water Resource Recovery Facility (WRRF) or a Sewage Treatment Plant (STP) in the case of domestic wastewater. Pollutants in wastewater are removed, converted or broken down during the treatment process.

  • Water Pollution Control A Guide to the Use of Water

    X.2 Description of the region X.3 Water systems X.4 Water resources assessment X.5 Pollution sources X.6 Major problems X.7 The programme X.8 International co-operation X.9 Conclusion X.10 References Case Study XI Cyprus XI.1 Introduction XI.2 Water resources XI.3 Measures to conserve and replenish groundwater XI.4 Direct use of treated wastewater for irrigation XI.5 Pollution of water

  • Chapter 3 Wastewater Facilities Operations and Performance

    Figure 3-23. Southeast Water Pollution Control Plant Annual Average Dry-Weather Influent Flow Rate..3-38 Figure 3-24. Southeast Water Pollution Control Plant Diurnal Flow Pattern for 2004..3-38 Figure 3-25. Oceanside Water Pollution Control Plant Average Annual Dry-WeatherInfluent Flow Rate....3-39 Figure 3-26. Oceanside Water Pollution

  • Step by step process of how wastewater (sewage) is treated

    The water at this stage is almost free from harmful substances and chemicals. The water is allowed to flow over a wall where it is filtered through a bed of sand to remove additional particles. After that, the filtered water is discharged into the river. *This description is not a standard for all treatment plants, but the principle is similar.

  • Water pollution Causes, Effects, & Facts Britannica

    Water pollution, the release of substances (such as chemicals or microorganisms) and energy (in the form of radioactivity or heat) into surface and subsurface waters to the point where they interfere with beneficial use of the water or with the natural functioning of ecosystems.

  • Water Pollution Control Plant History and Process

    Water Pollution Control Plant History and Process Plant History The following information provided is based on current plant operational parameters. When the plant was first established, the design flow was 16 million gallons per day. Since the departure of the Plattsburgh Air Force Base, the closure of the Imperial Paper Co. Mill, and major users using less water and reducing the amount of

  • Water Pollution & its Control Causes, Effects & Control

    A very special plant, the Water Hyacinth can absorb dissolved toxic chemicals such as cadmium and other such elements. Establishing these in regions prone to such kinds of pollutants will reduce the adverse effects to a large extent. Some chemical methods that help in the control of water pollution are precipitation, the ion exchange process, reverse osmosis, and coagulation. As an individual

  • Chapter 3* Technology Selection WHO

    Water Pollution Control A Guide to the Use of Water Quality Management Principles treatment plant in order to ensure process and performance stability. To accommodate possible fluctuations, equalisation or buffer tanks are provided to even out peak flows. Fluctuations in domestic sewage flow are usually repetitive, typically with two peak flows (morning and evening), with the minimum

  • Chapter 3 Wastewater Facilities Operations and Performance

    Figure 3-23. Southeast Water Pollution Control Plant Annual Average Dry-Weather Influent Flow Rate..3-38 Figure 3-24. Southeast Water Pollution Control Plant Diurnal Flow Pattern for 2004..3-38 Figure 3-25. Oceanside Water Pollution Control Plant Average Annual Dry-WeatherInfluent Flow Rate....3-39 Figure 3-26. Oceanside Water Pollution

  • Wards Island Water Pollution Control Plant Water

    Ward’s Island Water Pollution Control Plant (WPCP) is situated on Ward’s Island in the East River of Manhattan, New York City, US. The plant was built under the Robert F Kennedy Bridge and occupies about a quarter of Ward’s Island. It is the second largest of the 14 wastewater treatment projects in New York, after Newtown Creek. The plant serves dense populations (about one million) in

  • Water Pollution Facts, Types, Causes and Effects of Water

    When water pollution causes an algal bloom in a lake or marine environment, the proliferation of newly introduced nutrients stimulates plant and algae growth, which in turn reduces oxygen levels

  • Water Treatment Plant Model Version 2.0 User's Manual

    WATER TREATMENT PLANT MODEL Version 2.0 User's Manual May 18, 2001 Prepared by the Center for Drinking Water Optimization University of Colorado at Boulder Boulder, CO 80309-0421. WTP Model v. 2.0 i 05/18/01 Manual The WTP Model was developed for the United States Environmental Protection Agency (USEPA) by the Center for Drinking Water Optimization, University of Colorado Boulder and

  • Water and Wastewater Treatment Plant System Operator

    Water treatment plant and system operators work in water treatment plants. Fresh water is pumped from wells, rivers, streams, or reservoirs to water treatment plants, where it is treated and distributed to customers. Water treatment plant and system operators run the equipment, control the processes, and monitor the plants that treat water to make it safe to drink.

  • Pollution Control Systems and Devices Used to Control

    20/10/2020· Common air pollutants produced by industrial processes. Image Credit: Zdenek Sasek/Shutterstock . In this day and age, pollution control systems are a must. Air pollutants are generated through both natural—e.g., volcanic eruptions and wildfires—and human-made sources—including mobile and stationary ones.

  • Water pollution Causes, Effects, & Facts Britannica

    Water pollution, the release of substances (such as chemicals or microorganisms) and energy (in the form of radioactivity or heat) into surface and subsurface waters to the point where they interfere with beneficial use of the water or with the natural functioning of ecosystems.