ABOUT

Solutions & Cases

Our Case
  • Use of stone powder in concrete and mortar as an

    mortar found from stone powder which is 33.02 Mpa, shows that better mortar can be prepared by the stone powder. The compressive strength of concrete from stone powder shows 14.76% higher value than that of the concrete made of normal sand. On the other hand, concrete from brick chip and stone powder produce higher compressive value from that of brick chip and normal sand concrete. Key

  • Effects of crushed stone waste as fine aggregate on mortar

    In this study, effects of crushed stone waste from Katunun's quarry as fine aggregate on mortar and concrete properties will be examined. Samples with varying crushed stone waste replacement ratio, ranging between 0% until 100%, will be analysed at 3, 7 and 28 days curing time. Mortar sample is using 0.5 w/c ratio, while concrete sample is using 0.45 w/c ratio. The mixture of mortar sample is

  • Effects of crushed stone waste as fine aggregate on mortar

    In this study, effects of cr ushed stone waste from Katunun's quarry as fine aggregate on mortar and concrete p roperties will be exami ned. Samples with varying crushed stone waste replacement...

  • What are the roles of aggregate in the mortar?

    The aggregate is a component in the mortar with the largest dosage and the lowest cost. It has relatively good volume stability and high strength. Some aggregates also have good thermal insulation properties. The performance of aggregate can affect the effects of other components.

  • Concrete-Based and Mixed Waste Aggregates in Rendering

    The former is composed of concrete waste, and MRA is based on various constituents such as concrete, mortar, ceramic and other contaminants. Each of the recycled aggregates was incorporated in mortars replacing sand at 0% (REF), 20% (RCA20 or MRA20), 50% (RCA50 or MRA50) and 100% (RCA100 or MRA100), by volume.

  • WASTE MATERIALS USED IN MAKING MORTAR AND CONCRETE

    As a partial substitute for fine aggregate, i.e. sand, the following can be used: blast furnace slag 51-54, fly ash 55-57, silica fume 58, 59as well as stone dust. They constitute waste that is created, among other things, in the production process of crushed-stone aggregates.

  • Usage potential of recycled aggregates in mortar and

    Experimental results presented here on the properties of mortar and concrete when C & D waste and IOT are used as an alternative to fine aggregate for replacing the scarce river sand are promising

  • Laying Natural Stack Stone Using Mortar Home Guides

    27/12/2018· Laying Natural Stack Stone Using Mortar. Natural stone is often laid in a "dry stack" style without any mortar, but mortar stabilizes the stones to keep them from falling off the wall. Mortar is

  • Aggregates & Building Materials Breedon Group

    Breedon Special Aggregates Our Special Aggregates team produces a range of decorative aggregates, including our award-winning Breedon Golden Amber Gravel. Visit Breedon Special Aggregates. All our materials are quality-tested in state-of-the-art laboratories and can be tailored to your specific requirements.

  • How to calculate the cement, sand, and stone in stone

    Suppose you want to know about the quantities of cement, sand and stone in the case of RRMasonry in cement mortar 1:6, we can calculate like this for one unit of 10 cu.m:- RANDUM RUBBLE STONE 10 cum Bond stone 1 cu. cement mortar 1:6: 3.4cum which...

  • Effects of crushed stone waste as fine aggregate on

    In this study, effects of crushed stone waste from Katunun's quarry as fine aggregate on mortar and concrete properties will be examined. Samples with varying crushed stone waste replacement ratio, ranging between 0% until 100%, will be analysed at 3, 7 and 28 days curing time. Mortar sample is using 0.5 w/c ratio, while concrete sample is using 0.45 w/c ratio. The mixture of mortar sample is

  • Effects of crushed stone waste as fine aggregate on

    In this study, effects of cr ushed stone waste from Katunun's quarry as fine aggregate on mortar and concrete p roperties will be exami ned. Samples with varying crushed stone waste replacement...

  • Concrete-Based and Mixed Waste Aggregates in

    The former is composed of concrete waste, and MRA is based on various constituents such as concrete, mortar, ceramic and other contaminants. Each of the recycled aggregates was incorporated in mortars replacing sand at 0% (REF), 20% (RCA20 or MRA20), 50% (RCA50 or MRA50) and 100% (RCA100 or MRA100), by volume.

  • Usage potential of recycled aggregates in mortar and

    Experimental results presented here on the properties of mortar and concrete when C & D waste and IOT are used as an alternative to fine aggregate for replacing the scarce river sand are promising

  • Properties Of Cement Mortar Incorporating Solid Waste

    Properties of Cement Mortar Incorporating Solid Waste as Fine Aggregate: a Review K.I. Syed Ahmed Kabeer and Ashok Kumar Vyas investigated the performance of cement mortar made with marble powder as fine aggregate. Fine aggregate was replaced with marble powder in steps of

  • Laying Natural Stack Stone Using Mortar Home Guides

    27/12/2018· Laying Natural Stack Stone Using Mortar. Natural stone is often laid in a "dry stack" style without any mortar, but mortar stabilizes the stones to keep them from falling off the wall. Mortar is

  • (PDF) Stone Dust in Concrete: Effect on Compressive

    It is most essential to develop eco-friendly concrete from stone waste.In this research study the(PPC) cement has been replaced by stone waste accordingly in the range of 0%, 10%, 20%, 30% 40%

  • Aggregates & Building Materials Breedon Group

    Breedon Special Aggregates Our Special Aggregates team produces a range of decorative aggregates, including our award-winning Breedon Golden Amber Gravel. Visit Breedon Special Aggregates. All our materials are quality-tested in state-of-the-art laboratories and can be tailored to your specific requirements.

  • Aggregates & Gravel Online Bulk Bags, Handy Bags

    Aggregate. 17 Products. Filters. Range. Bulk Bag (4) Handy Bag (4) Thickness. 10 mm (2) 20 mm (2) Weight. 25 kg (8) 800 kg (8) Manufacturer Name. GRS Bagging Ltd (5) Various (8) Brand. GRS (5) JEWSON (8) Unbranded (4) Coverage. 0.8 m2 (4) Close. Close. Filter (0) Sort by Sort. JEWSON Gravel/Shingle 10mm Bulk Bag. AGSTB006. SKU: AGSTB006. Trade Sign in or apply for trade prices

  • How to calculate the cement, sand, and stone in stone

    Suppose you want to know about the quantities of cement, sand and stone in the case of RRMasonry in cement mortar 1:6, we can calculate like this for one unit of 10 cu.m:- RANDUM RUBBLE STONE 10 cum Bond stone 1 cu. cement mortar 1:6: 3.4cum which...